Better Homes And Gardens Diy Fire Pit

How to do it

Part 1

hand mixing cement

Step 1

Create Cast Mixture

Wearing a dust mask and gloves, blend equal parts of white cement, quartz sand, and perlite in a large tub. Slowly add water, and mix the concrete with a plastic trowel to form a consistency of soft dough that holds its form when squeezed into a handful.

Safety Tip: Always wear a dust mask when working with concrete and cement to avoid the small particles getting in your lungs.

adhering pipe for fire pit drainage hole

Step 2

Create a Drainage Hole

Use a hot glue gun to attach a short piece of pipe to the center of your large planter. Let dry. This will create a drainage hole when you add the concrete.

spray inside of large mold with vegetable oil

Step 3

Make Molds Non-Stick

Prepare the planter molds by spraying vegetable oil on the inside of the large one and the outside of the small one. If the containers are not oiled, the concrete will adhere to the plastic mold. If you don't have an oil spray on hand, using a paintbrush to rub oil on the molds works, too.

add concrete to plastic mold with shovel

Step 4

Place Mixture in Mold

Working quickly, shovel prepared concrete into the large planter, roughly forming a bowl shape approximately 2 inches thick. Avoid shoveling concrete over the pipe opening.

place chicken wire into bowl with mix

Credit: Cameron Sadeghpour

placing inside larger planter with mix

Credit: Cameron Sadeghpour

add concrete around inner plastic mold

Credit: Cameron Sadeghpour

Step 5

Create the Bowl Basin

Press a sheet of chicken wire into the concrete, bending it into a bowl shape. This will provide extra support inside the finished concrete "walls." Press the small planter firmly into the center; push hard to shape and smooth the inside of the fire bowl. You might need to set some bricks or heavy rocks inside to hold it in place while you add additional concrete around the edges. Cover the concrete bowl with a sheet of plastic; let cure for three days before you move it.

Editor's Tip: If you notice bubbles in your wet concrete mixture, lightly tap the exterior bowl with a rubber mallet to allow the bubbles to rise to the top. If that doesn't do the trick, gently run a palm sander around the perimeter of the exterior bowl to loosen up the air pockets.

remove top planter mold from concrete

Credit: Cameron Sadeghpour

remove concrete firebowl from plastic molds

Credit: Cameron Sadeghpour

Step 6

Remove Fire Bowl from Mold

When cured, remove the plastic and inner planter, carefully turn over the large plastic planter, and tip out the concrete bowl. Wrap the fire bowl in the sheet of plastic, and allow it to cure in a shaded place for three weeks. When hard and dry, file the top edge of the bowl smooth.

Editor's Tip: Recruit a friend or family member to help remove the concrete form from the mold and use caution to make sure your fingers (and the form) aren't damaged in the process.

placing rocks in fire bowl

Step 7

Add Stones and Fire Gel

Fill the concrete bowl with fire-safe decorative stones. Tuck cans of solid-gel fuel among the stones, using one, two, or three cans of fuel—the more cans of fuel, the hotter the fire. If you prefer, the concrete is also safe to use with logs.

Safety Tip:Cooking food, including marshmallows, directly over a gel fuel flame is not recommended. If you plan to use your fire bowl for cooking, use real logs instead.